St3300v Suntech

ST3300V The ST3300V is a telemetry device designed for multiple interactions, such as vehicle tracking. It allows for crash or collision notification, fine tracing of the routes traveled by the vehicle, as well as monitoring of the vehicle itself. It has multiple inputs and outputs, with which you can implement all security solutions. Additionally, it has bidirectional voice support that allows you to communicate with the occupants of the vehicle. Some of its features include Jammer detector, voice kit, SCUTI maintenance, and unified Suntech protocol.

Specifications

Manufacturer Model Type I/O Battery Communication Methods
Suntech ST3300V GPS N/A Yes - Internal Battery GSM/LTE

Features

INTERFACES
Power Source: DC 8V~33V (Electronic overvoltage and reverse power protection)
Battery Interface: 10-pin cable connector / 4-pin cable connector (Voice kit)
LED Indicator: 3G and GPS network status
GPRS Antenna: Internal
Accelerometer: 3-axis accelerometer (Driving pattern analysis, shock, and collision alerts)
 
GENERAL FEATURES
Memory Capacity: Up to 10,000 positions
Geofences: 255 circular, 30 polygonal
SIM CARD Size: Micro SIM 3FF / SIM Holder: Push Push
Power Source: DC 8V~33V (Electronic overvoltage and reverse power protection)
Low Battery Consumption: Typical: 40~50 mA @ 12V / Sleep: Less than 4mA @ 12V / Deep Sleep: Less than 2mA @ 12V
Size: 90.5x58x26 mm
Weight: 115 g (with backup battery)
M2M Communications: Unified Suntech Protocol
Backup Battery: Rechargeable 3.7V, 450 mAh Ni-MH
Temperature Range: -30°C~+85°C
 
GNSS SPECIFICATION
Receiver Type: GPS or Glonass / GPS Band L1 (1575.42MHz), Glonass Band L1 (1601.71MHz) SBAS: WAAS, EGNOS, MASA
Acquisition: Cold start < 35s / Warm start < 30s / Hot start < 1s
Sensitivity: Tracking -167dBm / Reacquisition -161dBm / Acquisition -149dBm
Accuracy: Position 2.5m CEP / SBAS 2.0m CEP
ST3300V

Requirements

See the complete documentation
ST3300V

Programming

See the complete documentation
ST3300V

SMS Programming

See the complete documentation
ST3300V

Commands

See the complete documentation