The iStartek 2G VT200 GPS tracker is a waterproof device that uses a wide voltage range power supply of 9-100 V, with quad-band support for 850/900/1800/1900MHz, 128 MB flash that stores buffer when the signal is lost to maintain a complete tracking route, dual camera and IP server that supports location data upload to two servers simultaneously, and multiple I/O 3IN + 2OUT+1AD+1RS232+1-Wire+1Speaker+1Microphone, 4IN/2AD configurable. Firmware update is quick and easy remotely; it has multiple positioning systems for high-precision real-time positioning GPS/BDS/GLONASS/QZSS, wide operating voltage of 9-100 V applied to all types of vehicles, RS232 port that can be equipped with a camera, RFID, magnetic card reader or OBD II reader; 1-Wire® can be equipped with up to 8 temperature sensors or ibuttons; it also supports sudden acceleration alarm, break alarm, sharp turn alarm, speeding alarm, drunk driving alarm, fatigue alarm, etc. and also supports ultrasonic fuel sensor or capacitive fuel sensor with fuel theft alarm.
| Manufacturer | Model | Type | I/O | Battery | Communication Methods |
|---|---|---|---|---|---|
| Istartek | VT200 | GPS | 3/3 | Yes - Internal Battery | TCP/UDP/SMS |
General Features
| Power Supply | 9V-100V |
| Dimensions | 99x54x19.5mm |
| Weight | 106g |
| Backup Battery | 500mAh |
| Normal Power Consumption | 65mA/hour |
| Working Time | 33 hours in power-saving mode and 7.5 hours in normal mode |
| Operating Temperature | -20°C to 75°C |
| Humidity | 5% to 95% non-condensing |
| Memory | 128M bits |
| Waterproof Level | IP66 |
| Positioning | GPS+BD2 |
GSM Specifications
| Frequency | GSM: 850/900/1800/1900 MHz |
| 2G Module | M26, 2G, 4 frequencies, Quectel |
| Data Transmission | GPRS: Max. 85.6 Kbps (DL)/Max. 85.6 Kbps (UL) |
| GSM Data Transmission | Multislot Class 12 |
GNSS Specifications
| GPS Type | Airoha AG3331 |
| Sensitivity | Acquisition -149dBm Tracking -167dBm Reacquisition -162dBm |
| Position Accuracy | Autonomous: < 2.5m CEP |
| Velocity Accuracy | Uncorrected: <0.1 m/s |
| Channels | 33 (Tracking)/99 (Acquisition) |
| TTFF (Open Sky) | Cold Start: <26 s Hot Start: <15 s Warm Start: <1 s |
| Reacquisition Time | <1 second |
Interfaces
| Digital Inputs | 2 positive trigger inputs (all 3 inputs can be configured as high and low trigger modes, AD1 can be configured as a high-level trigger input), 1 negative trigger input |
| Digital Outputs | 2 digital outputs, open-drain, max. drive current of 500 mA |
| Analog Inputs | 1 analog input (0 V-36 V), input 3 can be configured as AD2 (0-6.6 V) |
| 1-Wire Interface | Supports 1-Wire temperature sensor/button i |
| Power Output | 5V outputs for external accessories |
| Communication Ports | 1 RS232 port for external accessories, such as RFID reader, magnetic card reader, etc. |
| Cellular Antenna | Internal antenna |
| GNSS Antenna | Internal antenna |
| LED Indicators | CELL, GNSS |
| Microphone | External MICROPHONE |
| Speaker | External Speaker |
Wireless Interface Protocol
| Transmission Protocol | TCP, UDP, SMS |
| Scheduled Reporting | Position and status reporting based on predefined time intervals, distance, mileage, or a combination of these settings |
| Geofences | Geofence alarm and parking alarm |
| Low Power Alarm | Alarm when the backup battery is low |
| Ignition Report | Report when the device is turned on |
| Driving Behavior Monitoring | Detection of aggressive driving behavior, including acceleration, deceleration, overspeeding, etc. |
| Fuel Monitoring | Oil theft alarm, low oil alarm |
| Temperature Monitoring | High-temperature alarm, low-temperature alarm |
| Towing Alarm | Alarm after the vehicle's parking is towed |
| Idle Alarm | Idle stop without shutdown alarm |
| Remote Control | OTA control of digital outputs |
| Firmware Over-the-Air (FOTA) | Support for firmware updates over the air |
| OBD II Reader | Read engine speed, water temperature, etc. |
| Camera | Under development |
| RS232 | Green line RX, white line TX |
| Protocol | New iStartek protocol |
ES
PT
